https://youtu.be/M6OUwGikWKg
Easier than you might expect. This is a great way to make any momentary switch/button into a latching switch.
https://youtu.be/M6OUwGikWKg
Easier than you might expect. This is a great way to make any momentary switch/button into a latching switch.
Hi Rob ,
I dont have the ability to make a wiring diagram at the moment but what I want to do is use a 12mm av momentary switch to replace the latching one on my Makoto string blade. my questions are do I need to wire a ground from the battery for the board ? and since its a string blade without a ground on a LED die to attach to will it cause a problem? how would you wire this ? 1543dbd7789d44.jpg
the translation is difficult as is getting a hold of him. I can tell you that in one instance I substituted a capacitive touch sensor switch into another Makoto
i have and just ran a ground from the battery compartment and it worked fine , I guess
i'll give it a go and see what happens.
Ok, so to use this Momentary to Latching convertor with Makoto's system is pretty straight forward . I ran a ground from the battery compartment to the ground in on the converter board, then I disconnected the 2 leads from the supplied latching switch to the V in and V out. then for the led on the switch I used the second V out with a resistor and Ground out. If it does not power on right away change the polarity on the board connection.
Last edited by Contrasteve; 06-08-2015 at 05:37 PM.
Bookmarks