New to Lightsaber Scene -- building new lightsaber

[metalsuspension]

Hey all,
I just recently got into the lightsaber scene. After purchasing a lightsaber from (don't kill me) Ultrasabers, I've decided that I was to fully customize my own.
I've been talking to a friend of mine about the parts I need; here's my parts list as is:

• Hilt style 4 with machine guarded switch hole 1.5? from end
• Double ended male threaded connector style 1
• 4? double female grooved without holes
• MPS Pommel style 4
• MHSV1 blade holder style 10
• MHS Heat sink V3
• Red Cree XP-E2 CopperNova
• 4AA Battery Holder with JST connector
• 16mm Anti Vandal latching red ring switch
• LED TCSS Show blade 1? OD

I believe that the only supplies that I need now are tools for the wiring and a buckpuck and a resistor (for the LED on the switch and the blade LED).

Any suggestions for electronics besides the LED and switch are welcome!

[setelf3of5]

Welcome

[MedicineMan]

Do not forget about:

MPS inserts and a C clip to hold the insert into the pommel. Also, you will want to get a buckpuck or a resistor of some sort for your LED.

[metalsuspension]

Do not forget about:

MPS inserts and a C clip to hold the insert into the pommel. Also, you will want to get a buckpuck or a resistor of some sort for your LED.

True, I forgot about the insert and C clip.

I'm not sure what buckpuck or resistor to purchase, though. I'm also not sure how to wire the setup correctly.

[cvsickle]

Then you might want to start here: http://forums.thecustomsabershop.com...ke-a-LED-saber

[MedicineMan]

if it is for a simple stunt saber, then you will choose either resistor or buckpuck.