Momentary to Latching Converter Question

[Experienced Noob]

How exactly is the M-L Converter supposed to be wired? I've looked on the forums and only found references to its use, but never an actually explanation of how to use it. A basic diagram would be immensely helpful.

Also, if this is in the wrong section, I apologize, I wasn't exactly sure where to put it.

[Silver Serpent]

Connect the battery pos to VIN, connect the battery neg to one of the GND spots. It doesn't matter which, just pick one.
Connect the pos of your LED (or whatever you want powered) to the VOUT, and the neg to another GND.
Connect the momentary switch terminals to the spots where you see the switch in the picture (bottom center, between the GND pads).

[Sidd]

I wired a Pololu board to a MRFX board recently and had a great result

this is the diagram i used

[Experienced Noob]

Thank you both very much!