the blade will light up under the audio player font but none of the other fonts i do not have a RICE cable yet
the blade will light up under the audio player font but none of the other fonts i do not have a RICE cable yet
i got it to work had to hit the 2 buttons at the same time to get it to the right channel.
i need a rice cord.
If you're only using one color, then you should delete all of the color profiles from the override file. Doing that will mean the LED parameter in the config file in each bank folder will define the blade color.
I just did that to assemble the saber waiting for a Color Xtender to come back in stock so i can do different color blades.
Well, diameter is dependent on your blade holder. Typically that is 1", unless you want to use a reducer for the 7/8" or 3/4" blades.
For length, use what is comfortable to you. An average height human is usually good with a 34-36" blade. A general rule of thumb is that you don't want the tip of your blade to be striking the ground, so adjust the length accordingly.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
so far it is 40" i don't hit the ground with it i hit the ceiling and its a 9' ceiling i was hoping there was a way to calculate it out.
it is balance at 1/2" past the blade holder
Bookmarks