First Timer help

[Andrewrox96]

Hey there, I would like to know if these would all work together and be good to go.
Parts in my wishlist.
http://www.thecustomsabershop.com/Vi...shlistId=42986


it will look like this in the end http://gyazo.com/c08c991c53a902d59bc55dfd752ec6ec

[cvsickle]

Your pommel insert and o-ring are for a V2 pommel. You have a V1 pommel selected, so you'll need to get a V1 pommel insert and clip instead.

Also, you'll need a latching circuit. Either replace your switch with a latching switch, or get a momentary to latching converter.

[Andrewrox96]

Ok so I will switch the inserts and get a clip and will switch to a latching switch? Anything else I am missing, I have a resistor for the switch led. Will I need extra wiring?

[cvsickle]

Also, you have a 6 wire buck puck selected. Do you have a potentiometer you plan on using as a dimmer? If not, you could go with a 4 wire version to simplify the design.

[Andrewrox96]

I do not have a dimmer option, I am trying to go as simple as I can as I can always re-wire in the future, so go for a 4- wire puck? anything else I would need?

[Andrewrox96]

Also is the latching switch I chose too long for the hilt? It seems very long and like the wires would not fit. Also do I need a bezel for the switch or is it a cosmetic upgrade?

[cvsickle]

The bezel will help give more room for your switch inside the hilt.

[Andrewrox96]

Ok so with the jst female batter, the jst male on the led and the wiring needing to be on the switch with a resistor for the switch would you be able to help me figure out a wiring guide? Or should I post that to the wiring section? is this image what I should follow ignoring the other LED before the main LED? http://gyazo.com/419364578ea6bbd584b4479c5f3a50bc

[Andrewrox96]

Is the 16mm Latching blue switch compatible with handle #3?

[setelf3of5]

welcome, and good luck on your build