-
First Timer help
Hey there, I would like to know if these would all work together and be good to go.
Parts in my wishlist.
http://www.thecustomsabershop.com/Vi...shlistId=42986
it will look like this in the end http://gyazo.com/c08c991c53a902d59bc55dfd752ec6ec
Last edited by Andrewrox96; 01-20-2015 at 09:31 AM.
-
Your pommel insert and o-ring are for a V2 pommel. You have a V1 pommel selected, so you'll need to get a V1 pommel insert and clip instead.
Also, you'll need a latching circuit. Either replace your switch with a latching switch, or get a momentary to latching converter.
-
Ok so I will switch the inserts and get a clip and will switch to a latching switch? Anything else I am missing, I have a resistor for the switch led. Will I need extra wiring?
-
Also, you have a 6 wire buck puck selected. Do you have a potentiometer you plan on using as a dimmer? If not, you could go with a 4 wire version to simplify the design.
-
I do not have a dimmer option, I am trying to go as simple as I can as I can always re-wire in the future, so go for a 4- wire puck? anything else I would need?
-
Also is the latching switch I chose too long for the hilt? It seems very long and like the wires would not fit. Also do I need a bezel for the switch or is it a cosmetic upgrade?
Last edited by Andrewrox96; 01-20-2015 at 10:55 AM.
-
The bezel will help give more room for your switch inside the hilt.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks