Results 1 to 4 of 4

Thread: Can the MHSv1 copper heatsink fit into the holder of an MHSv2 Heat Sink

  1. #1

    Default Can the MHSv1 copper heatsink fit into the holder of an MHSv2 Heat Sink

    Looking at building an MWS based setup but my blade holder is an V2. Can I buy the MWS LED and then swap the outer aluminum shell with a V2 version?

  2. #2

    Default

    I'm pretty sure the answer is no. The heatsink part looks smaller in the pictures.

    I would contact Strydur about having a v2 MWS LED module built instead.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

  3. #3

    Default

    Yeah, that is what I was figuring. I expect the aluminum shroud is smaller on the V2 but I was hoping the copper piece was simply the MHS V1 flat.

  4. #4
    Owner of the Custom Saber shop Strydur's Avatar
    Join Date
    Oct 2005
    Location
    USA
    Posts
    3,520

    Default

    It is smaller.. I will put MHS V2 MWS modules on the site soon.
    Tim
    The Custom Saber Shop

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •