Nano Biscotti v2 Settings/Sensitivity
Hi all,
I've built two NB sabers now and both seem to have the same problem - the swing sounds are really hard to activate. The hilt has to be really tossed around or rapidly swung to get much and I haven't had a lot of luck with adjusting the settings on the configure file. I did use the NB/speaker/li-ion holder from the shop, but I don't think that having the parts solidly in the hilt like that should hurt. Any recommendations? Has anyone else had this happen?
To adjust the sing sensitivity, typically you need to adjust the "I" parameter, raise it to make it more sensitive. If that doesn't help much, you may also need to tweak the "hs" and "ls" parameters and lower them some.
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
hmm... you may have the sound config on the "Light Meat" sound font? The swing sounds are generally softer, with more robust clashes. The "dark meat" is the one with better swing and clash noises (IMO)
I would also follow FJK's advice and change the parameters
~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Elegance doesn't compromise functionality.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Posting Permissions
Reply With Quote
Bookmarks