Diagram check
Hello, trying to build my first DIY stunt, just need to know if this will work or not.
Latching Switch Schematic.jpg
Planning to use the 12w LED that SaberForge sells on their site, which they say comes pre-resistored for a single 18650 battery, which is why the diagram doesn't include a resistor for the primary LED.
New to this, so it could totally be wrong, just trying to find out before I buy anything.
Thanks.
Welcome to the Forums.
It looks like it should work, though I (we) don't deal with or discuss products from that vendor here. I don't know how bright that LED would actually be.
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
Thanks for the reply
Sounds like there is some backstory here...
And you would be correct.Originally Posted by Miraluka
Sounds like there is some backstory here...I'm just not going to get into all of it.
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
Welcome Miraluka, good luck with your build. I look forward to seeing your saber.
Thanks!
Not sure if I'm going to build it this way or not. Been looking at Tri-Rebels but still a lot I don't understand about... you know, everything.
Posting Permissions
Reply With Quote
Bookmarks