Results 1 to 3 of 3

Thread: 16mm Switch?

  1. #1

    Default 16mm Switch?

    Hello, Forums (once again!)

    I have wired a 12mm switch before, but I am now looking at a 16mm. I am wondering how to wire it? I know the LED terminals are positive and negative, but where would my yellow wires on the nano biscotte (v2) go?
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~
    Elegance doesn't compromise functionality.
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  2. #2

    Default

    NEVERMIND! Lol I found the short version ;3
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~
    Elegance doesn't compromise functionality.
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  3. #3

    Default

    Depends on the switch. There are two types of 16mm illuminated switches in the store. There are the 4-post ones like this: http://www.thecustomsabershop.com/16...itch-P616.aspx and the DPDT ones with 8 posts like this: http://www.thecustomsabershop.com/16...itch-P413.aspx

    For the 4-post version, just connect the yellow wires to the two non-LED posts.

    For the 8-post version, connect one yellow wire to C1, and the other yellow wire to NO1.

    Wire the switch LEDs as normal.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •