Hopefully this is correct, please let me know If I am to wire anything differently.
I am planning on using an 18650 with a illuminated red switch and Rebel LED.
Wiring Diagram
Hopefully this is correct, please let me know If I am to wire anything differently.
I am planning on using an 18650 with a illuminated red switch and Rebel LED.
Wiring Diagram
Looks right to me. If you're planning on hooking up everything with JST connectors, be advised that they'll take up a lot more room than you'd expect. Wiring everything directly will save you a ton of space in your hilt.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Alright thank you. Should I remove the JST from the LED and connect it to 24AWG wire, or should I buy a female JST for that particular piece?
A JST on your LED is not bad. It makes swapping out different colors much easier. If you don't think you'll be changing it out, then you should be fine wiring it in directly.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Thank you
Bookmarks