-
-
Jedi Padawan
I tried that set up with the older version of this box. The RC port was too big to fit in the middle of the box. The new box 1 style looks a little tighter than its older brother. I was able to do a switch mount inside that box using this switchhttp://www.thecustomsabershop.com/Red-momentary-switch-P559.aspx but even then it left little room for anything else roughly the box is 2"x.25"(inside) almost .25" tall (on the inside)
I had considered this set up again, but could not find a 3 pin RC port small enough to fit. Of course that said, its been awhile since I've gone looking. I hope this helped.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks