Box 1 Question

[Machinimax]

I'm looking to possibly getting one of these boxes from the store.

http://www.thecustomsabershop.com/Ac...sign-P354.aspx

Here's my question. Does anyone know how wide and how deep the hollow space inside the box is? The reason I'm asking is because I would want to drill a hole in the side of the box to mount a 2.1 mm recharge port and I want to make sure there is enough room inside. Thanks everyone!

[Noyl Wendor]

I tried that set up with the older version of this box. The RC port was too big to fit in the middle of the box. The new box 1 style looks a little tighter than its older brother. I was able to do a switch mount inside that box using this switchhttp://www.thecustomsabershop.com/Red-momentary-switch-P559.aspx but even then it left little room for anything else roughly the box is 2"x.25"(inside) almost .25" tall (on the inside)
I had considered this set up again, but could not find a 3 pin RC port small enough to fit. Of course that said, its been awhile since I've gone looking. I hope this helped.