Results 1 to 1 of 1

Thread: Tutorial - FJK's "Down and Dirty" guide to Ohm's Law

  1. #1

    Post Tutorial - FJK's "Down and Dirty" guide to Ohm's Law

    Ohm's Law - the down and dirty guide to "Doing the Math" yourself.

    Ohm's Law comes in two parts, meaning there are two values you need to calculate. The "Ohms" value and the "Watts" value. The formulas for both are as follows:

    R <Ohms> = (VfBattery - (VfLED1 + VfLED2)) / I

    Where:
    Vf Battery = Battery Voltage (usually either 3.7V or 7.4V)
    Vf LED1 = Forward Voltage of LED #1
    Vf LED2 = Forward Voltage of LED #2 (If you have a second in series)
    I = (in Amps) Current you wish to run your LED at (Rebel Reds and Red-Oranges are usually 700 mA, Cree Reds, Red-Oranges, and ALL Blues, Greens and Whites are usually 1A)

    The second part of the formula is as follows:

    P <Watts> = R * I^2

    Where:
    R = the resistance value from the first calculation
    I = (in Amps) Current you wish to run your LED at (Rebel Reds and Red-Oranges are usually 700 mA, Cree Reds, Red-Oranges, and ALL Blues, Greens and Whites are usually 1A) - This value needs to be squared in your calculation.

    In the following example, I calculate a resistor value for a single Rebel Red LED
    (Vf= 2.4V) running at 700mA running it off of a 3.7V battery.

    R = (3.7 - 2.4) / .7 ==> 1.3/.7 ==> 1.86 ----> Rounded up to 2 Ohms

    P = R * I^2 ==> 1.86 * (.7)^2 ==> .91W ---> Rounded up to 1W

    Since there are only so many values that are commonly produced, it will be very likely that your will need to round UP to the next resistor size, to get the resistor that you would need (and as I did in the above example).

    So, I will need a 2 Ohm, 1W resistor.
    Last edited by Forgetful Jedi Knight; 04-19-2016 at 04:54 PM.
    TCSS MODERATOR
    All n00bs READ these first (PLEASE)!!!:
    1. Forum Guidelines
    2. FJK’s “Down and Dirty” guide to Ohm’s Law

    "Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
    My email: fjk_tcss@yahoo.com

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •