Page 10 of 10 FirstFirst ... 8 9 10
Results 91 to 94 of 94

Thread: Wiring Check, Please?

  1. #91

    Default

    sure.
    1. Download default NB V2 SD card setup from Plecter Labs
    2. Make sure you unzip it and have it on your desktop.
    3. After you're sure you have it, delete the files on the SD card
    4. Drag the files from the download into the blank SD card
    5. Put the SD Card Back in and you're done!

    This worked for me... be sure to back up your SD card

    Hope this helped

    Link: http://www.plecterlabs.com/catalog/a...rticles_id=107
    The thing you have to click is:
    ► Original archive - Nano Biscotte 2.x - Light Meat + Dark Meat + Configuration File)
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~
    Elegance doesn't compromise functionality.
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  2. #92

    Default

    okay! I'm back with a few questions!
    so my wiring works and I'm very pleased with it! Thanks for all of the helpful advice to y'all!
    So I have designed a chassis based on previous advice.
    The picture is attached. Please tell me if ANY ideas are better. I am just throwing ideas around ;3

    Here's the plan:
    Screenshot 2014-11-04 11.33.56.jpg

    Here's my parts list:
    http://www.thecustomsabershop.com/Ac...k-S3-P813.aspx
    http://www.thecustomsabershop.com/St...read-P770.aspx
    http://www.thecustomsabershop.com/2-...acer-P785.aspx
    Last edited by Yorginsnarff; 11-04-2014 at 09:35 AM.
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~
    Elegance doesn't compromise functionality.
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  3. #93

    Default

    That's the typical way to build a chassis with the parts here in the store. Don't forget the 4-40 hex nuts to hold everything together.

    Depending on how far you slide the chassis discs, you may need to modify the one nearest the wiring harness. The harness won't fit through the slot without modifying the chassis disc.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

  4. #94

    Default

    Thanks! I was only planning to slide the second chassis up to the harness, not slide over it
    Thanks for the missing part, too!
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~
    Elegance doesn't compromise functionality.
    ~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •