I have wired saber up befroe but it has always been with a buckpuck or a "kit" so this it the first one that I had to do all the work myself. Sooooo before I fry a board or LEDs I figure I would ask the pros here on the forum if it all looks good
Hardware
- 16mm Anti Vandal Momentary Gold Plated Switch
- Nano Biscotte Sound Module V2
- 2W speaker
- Amber 171 lm @ 700 mA 3.2V to run at 700 mA Rebel
- Single Trustfire 18650 3000 mAh 3.7V
- 1 Ohm 1/2 WATT resistor
- MWS Recharge Port
Thank you for looking guys. I am using MWS so I can change out LED or later make a better internal mount for the battery/sound card system.
Bookmarks