1st Build Parts List!

[Maulisimo]

1st Ever Stunt Saber Build.

SaberBuilder_render.jpg

MPS Pommel style 3 v1
MHS ribbed extension (Drill & Tap Hole (8-32) for covertec wheel)
3" Double female threaded connector (Machine recessed AV switch hole)
MHS choke style 1 short
Screw on LED blade holder style 16 (Drill & Tap Hole (8-32) for retention screw) with 8-32 x .3" red thumb screw
Machined button for Covertec clip with 8-32 x 1/2" button head screw
MPS Insert style 4 with MPS Clip

THE ELECTRONICS:

MHS "new style" Heat Sink V2
TrustFire Protected 3.7V 900mAh 14500 Lithium Battery (2-Pack)
Luxeon Rebel Star (Green)
BuckPuck 1000mA 4-wire
Collimator Lens 8.7 deg viewing angle with Luxeon Rebel Lens Holder
16mm Anti Vandal Short Latching Green Ring Switch
220ohm 1/4w resistor
This is the diagram I will be using.
saber wirein diaram.jpg

BLADE:
LED "TCSS style" Show blade 1" OD (36 inches)

Any suggestions?

[Silver Serpent]

Everything looks fine. You will need to recharge the batteries outside the hilt, since they're individually protected and not in a pack.

I would also grab one of these: http://www.thecustomsabershop.com/St...-pad-P483.aspx to help hold the LED star to the heat sink and help with heat transfer.

[Maulisimo]

Everything looks fine. You will need to recharge the batteries outside the hilt, since they're individually protected and not in a pack.

I would also grab one of these: http://www.thecustomsabershop.com/St...-pad-P483.aspx to help hold the LED star to the heat sink and help with heat transfer.

Thanks for the suggestion! I'll be sure to add that to my list. Would it be possible to add sound later on?

[Forgetful Jedi Knight]

Yes, but you will need to get rid of the buck puck if you decide to add sound.

[Silver Serpent]

Note to self: stop posting before coffee.

You'll want to replace that momentary switch with a latching switch. On a stunt build, you want latching switches or you'll have to hold the button down all the time.