Hello,
I am working on my first Saber and I am thinking of adding a force feedback motor, connected to the PC board and a AV switch to turn it on or off as required.
Motor: Cell phone moto razr, I believe it runs at 100mA and its 2V.. not 100% sure but this should be safe (I hope)
AV Switch: Green dot LED. fv: 3.3V @ 20mA
3 rebel star: GGW
I would like to know from the forum experts if this diagram is correct and it meets the Resistance required to drive the motor.
diagram1.jpg
Thank you !!!
Rob
Bookmarks