Petit Crouton Won't function!

[Renaissance Jedi]

So I have my petit crouton 2.0 all wired up (correctly) I put the SD card in after making the necessary changes to the config file. I pull out the kill key, the boot sound activates as it should. I activate the saber, the poweron sound plays, and then it immediately plays the boot sound again. It then plays the boot and poweron sounds in a loop until I reinsert the kill key. Why is this? Have I done something wrong?

[Ty_Bomber]

What kind of switch are you using and what is the switch setting configured to?

[Renaissance Jedi]

I'm using a latching switch, and the switch setting is set to 1.

[Renaissance Jedi]

I'm really not sure what could be causing this issue.

[amwolf]

With the entire wiring setup sitting outside the hilt, does it still do it? If not, you may have a grounding issue... You could also try disconnecting the main LED then powering it up. Isolate and eliminate...
Alternatively, have you tried another SD card, just in case there's something wonky there?

[Renaissance Jedi]

There maybe something grounding out, but the wiring is so tight that I can't remove it. I did try a sound card with the workings form the PC 1.2 on it and that worked fine. I will try another sd card with the 2.0 stuff on it see if that works.