Hello saber-smiths,
After a few stunt builds under my belt, I am ready to graduate on to a sound build. I have read the Nano Biscotte manual and consulted the resistor charts on the website. I think I am ready but would appreciate it if someone with more knowledge could give me a courtesy check on my schematic. I tried to be as neat as possible with my diagram but I am no electrics expert. The blue squares are the JST connectors. I plan to use the pre wired sound board because I do not trust myself to solder on a board. I put the connectors in there so I do not get confused.




Components:
Nano Biscotte sound board- prewired.
Seoul P-4 LED in GREEN with 1 ohm 2 watt resistor
Accent LED #1 in RED
AV switch with GREEN dot
Dynaohm resistor for accent LED circuit
3.7 volt Li-Ion battery
Recharge port
Premium speaker

Things I am most concerned about:
Am I correct in wiring the main LED and the accent LED circuit in parallel?
Do I have the correct resistors for the LEDs (I pulled the information off the Resistor Chart but I could have pulled it wrong)?
Am I correct to wire the two accent LEDs in series with each other and use just one Dynaohm resistor?
Are the resistors in the right place (on the right legs)?
Is the recharge port configuration correct?
Any other advice or pointers?

Thank you very much in advance and may the Force be with you.