AV Style Long

[WINN3BAG3L]

I have looked quite a bit and have found nothing concerning how to wire an Anti-Vandal Momentary Long style switch with a NB soundboard. I had forgotten that there are extra prongs on the switch and did not account for it. Where would I have to wire them all into. I know that the two for the switch get wired directly onto the soundboard, and the switch positive and negative are wired to the LED positive and negative, but I am confused as to where the others go. Any help would be appreciated.

[Silver Serpent]

There's a diagram for the connections on the switch page: http://www.thecustomsabershop.com/16...itch-P434.aspx

Connect to the switch connections to C1 and NO1 and you should be good to go. Wire up the accent LED appropriately if you are using it.

[WINN3BAG3L]

What about the rest of them. Do I leave those unconnected to everything?

[Silver Serpent]

You'll normally use 4 of the connections on the switch. C1 and NO1 for the switching portion. LED+ and LED- for illuminating the switch. The others can be ignored.