I used another thread as a base for the items i need, I have no clue if this is even close so any help is HUGELY appreciated.
x1: 8-32 x 1/2" thumb screw
x1: LED "Corbin style" Show blade 1" OD (36 inches)
Quad Wrap
Bullet Shaped
x1: 8-32 Tap & drill set
x1: Tap handle
x1: 7" Fluted with guarded style switch hole
x1: Screw on LED blade holder style 20
x1: MHS "new style" Heat Sink V2
x1: MPS Pommel style 7
x1: Main Body Powder Coating (Wet Black) (DFS2)
x1: Blade Holder Powder Coating (Extreme Chrome) (B201)
x1: Pommel Powder Coating (Extreme Chrome) (PM71)
x1: Build Your Own Seoul P4 Electronics Kit
4AAA Battery Holder with JST connector
Seoul P4 (Red)
Collimator Lens 5° viewing angle
4.7ohm 5w resistor
(Switch07) SPST Push on/off - Mom switch with black button
Seoul P4 Lens Holder
x1: 16mm Anti Vandal Latching Red Ring Switch
x1: Red momentary switch
x1: MPS Clip
x1: MPS Insert style 6
x1: Black machined button for Covertec clip
x1: MHS speaker and 4x AAA battery holder
x1: Petit Crouton Sound Module V2.0
Light Meat
x1: 8-32 x 1/4" socket head
x1: Activation box style 19
x1: Box 19 Mounting holes service
location: Where the existing design hole goes if possible.
x1: Seoul P4 (Red)
x1: Collimator Lens 8.7 deg viewing angle
x1: Seoul P4 Lens Holder
x2: 26 gauge wire (sold by the foot) (Black)
x2: 26 gauge wire (sold by the foot) (Blue)
x2: 26 gauge wire (sold by the foot) (Brown)
x2: 26 gauge wire (sold by the foot) (Green)
x2: 26 gauge wire (sold by the foot) (Grey)
x2: 26 gauge wire (sold by the foot) (Orange)
x2: 26 gauge wire (sold by the foot) (Purple)
x2: 26 gauge wire (sold by the foot) (Red)
x2: 26 gauge wire (sold by the foot) (White)
x2: 26 gauge wire (sold by the foot) (Yellow)
saber diagram.jpg
Anything i've done wrong ie: something i do or dont need please let me know.
I have no clue whatsoever about electronics so small words are appreciated.
Bookmarks