How would i wire an illuminated switch in parallel to a pre-wired nano biscotte?
How would i wire an illuminated switch in parallel to a pre-wired nano biscotte?
To have the switch LED turn on and off with the blade? Wire up the switch LED to the LED (-) and the main (+) pads. Be sure to use a resistor.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Bookmarks