IMG_2322.jpgIMG_2324.jpgIMG_2326.jpg

I am a first time saber builder/solder'er/electronic fooler wither (as if that wasn't obvious) and thought I would just jump in head first after reading forums looking at wiring diagrams and watching vids. Well....... It didn't work, when I press the switch nothing happens >< I guess it might be a problem with the Recharge port? I was tring to wire it up to not work as a kill key. I thought maybe the wires were switched to the LED but I tried it both ways. I can take the LED put it in an allready premade saber and it works fine so I know it's atleast good.

all of the shown parts are as Follows:

MWS BuckPuck
SPST Short Latching AV Switch
2AA Battery Holder
2 Li-ion Batterys (14500 3.7V 900mAh)
2.1mm Power Jack

Any help is greatly appreciated!