Modifying standard switch hole to guarded switch hole. Anyone done it?
I have a main body with the standard switch hole. I am tired of the looks of my saber so I want to make it look different. I was wondering if it was possible to modify the standard switch hole to fit a guarded switch. If so how did you do it? Thanks!
Female Twi'leks are so Hot! I want one. Gotta love the lekku =0)~
It's certainly possible. Check out this thread for measurements: http://forums.thecustomsabershop.com...d-measurements
You may want an endmill bit to countersink the switch. I'm not sure what size you'll need, and it's not actually necessary (though it looks nicer).
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Use your dremel and bore it out bigger so that switch will fit. Done.
LED Saber Combat Master Instructor
Co-Founder of Caine and Novastar's Saber Combat System (NCSCS)
Life's short...saberplay HARD!
Thanks for the info everyone! I appreciate it.
Female Twi'leks are so Hot! I want one. Gotta love the lekku =0)~
Posting Permissions
Reply With Quote
Bookmarks