my config is correct?

[arnaud]

I just realize my config command.
I do not know if I forgot something?
here is my list.

Rebel Star LED & MHS Heatsink Module (Luxeon Rebel Star (Blue)
2AA Battery Holder with JST connector
16mm Anti Vandal Latching Amber Ring Switch
Brass bezel for illuminated switches

Pommel style 3
7" Fluted with standard style switch hole
MHS choke style 3
Screw on LED blade holder style 10 (MHS "new style" Heat Sink V2)
8-32 x 3/8" Stainless Steel thumb screw

LED "TCSS style" Battle blade 1" OD (26 inches)
1" Hilt safety plug (Trans White)

I know if I could have them all, and all compatible?
thank you
(I do not want to sound card)

[Silver Serpent]

You will need resistors for your main LED and the switch LED. http://led.linear1.org/1led.wiz can help you find the resistor value you need.

What type of batteries are you planning on using? If you're using ordinary alkalines, you won't have enough voltage to properly power the blue Rebel LED. You need at least 3 alkalines to run that LED.

You also don't need to add the heat sink with the blade holder. You get a heat sink with the pre-wired Rebel Module.

Edit: One more thing, you'll need to get the AV Switch Hole service if you want to use the AV switch in that hilt. It won't fit in the default hole.

[arnaud]

THANK YOU FOR YOUR REPLY
so I edit my list as follows.

Rebel Star LED & MHS Heatsink Module (Luxeon Rebel Star (Blue)
* 4AA Battery Holder with JST connector
16mm Anti Vandal Latching Amber Ring Switch
Brass bezel for illuminated switches
* BuckPuck 1000mA 4-wire


Pommel style 3
7" Fluted with standard style switch hole
MHS choke style 3
* Screw on LED blade holder style 10
8-32 x 3/8" Stainless Steel thumb screw


LED "TCSS style" Battle blade 1" OD (26 inches)
1" Hilt safety plug (Trans White)

* Machine AV switch hole

if my choice of "BuckPuck 1000mA 4-wire" just are there besion welding? or it is conector?
and my list is a good one this time?
thank you very much to you Silver Serpent