OK, BP and 2 Rebel question.

[rotccole]

OK,

I am making a saber staff,but a little differently. I don't want to give too much away so lets see here.

I need to know if it is possible to run two of these: http://www.thecustomsabershop.com/Re...dule-P653.aspx

One of these: http://www.thecustomsabershop.com/16...itch-P703.aspx

Off of this: http://www.thecustomsabershop.com/Bu...wire-P363.aspx

And a battery back (non-rechargeable).

Any help?

[Silver Serpent]

Short answer: maybe.

Since you have the 700mA buckpuck, and the red switch, I'm going to assume you're intending on using a red LED. If you wire the main LEDs in series, and have at least 4 alkalines, you should have enough power to run that setup.

A word of advice about buckpucks and alkalines: when the batteries start running low, the buckpuck will have issues starting up. It needs a minimum of 5v to operate. Alkaline batteries drain pretty fast, so use AA or larger sized ones if possible.