Pre-plannign 1st build, OD of 1.25LED?

[lord_emperor]

Forgive me if this is somewhere obvious, it probably is but I searched the forums exhaustively. I'm planning to make my own hilt, other than the LED / blade holder which I'd order here along with electronics. So the questions:

What's the outer diameter of the 1.25" Sink tube LED/Blade holder part # 1.25LED?

If it turns out to be unsuitable for my purposes, will 1.18blank or 1.25blank work with a Tri-Rebel or LEDEngin; what modifications would be necessary if so?

[Silver Serpent]

I'm pretty sure your first part's OD is a hair under 1.25". I would contact the store to be sure. Tim's a good guy, he'll let you know what you need to know about the parts.