My Parts List For Build

[jedimastergarcia87]

So here are my parts. I was wondering though, since I am using a P4 kit with the 5 degreee lens, is it better with a 32 inch or 34 inch blade? Both will be a trans white thin walled and corbin stytle thing walled dual wrapped. Thanks. I showed some of my friends and one of them thought the saber looked like Cade Skywalker's saber. I'm going to have the first black thumb screw in the middle of the angled part of the emmiter, 2nd more on the bottom, then the glass eye where the emitter curves down. Then I was going to have the switch in the middle of the upper grip under the glass eye. Should be getting this build done here soon. Its going to be a stunt so no sound. So let me know what you think.

Parts:

Dual 22 gauge wire



1/16Heat

1/16" Heatshrink tubing



Cclip

MPS Clip



MPSI4B

Brass MPS Insert style 4




8323TSB

8-32 x .3" black thumb screw



SeoulP4Kit

Build Your Own Seoul P4 Electronics Kit •4AAA Battery Holder with JST connector
•Seoul P4 (White)
•Collimator Lens 5° viewing angle
•3.3ohm 5w resistor
•Push on/push off switch with red button
•Seoul P4 Lens Holder




TWShow

LED Trans White Show blade 1" OD (34 inches) •** White Standard





DF4DEEPFL

4" Deep fluted double female threaded connector




DF4

4" Double female threaded connector




Sledholder12

Screw on LED blade holder style 12




NHS2

MHS "new style" Heat Sink V2




MPS5

MPS Pommel style 5




doublemale

Double ended male threaded connector style 1




GraflexEye

Graflex Glass Eye Replica Thumbscrew




Bmbutton

Black machined button for Covertec clip




8-32Cov

8-32 x 1/4" socket head





Corb1Show

LED "Corbin style" Show blade 1" OD (34 inches) •** Double Wrap
•** Standard