So here are my parts. I was wondering though, since I am using a P4 kit with the 5 degreee lens, is it better with a 32 inch or 34 inch blade? Both will be a trans white thin walled and corbin stytle thing walled dual wrapped. Thanks. I showed some of my friends and one of them thought the saber looked like Cade Skywalker's saber. I'm going to have the first black thumb screw in the middle of the angled part of the emmiter, 2nd more on the bottom, then the glass eye where the emitter curves down. Then I was going to have the switch in the middle of the upper grip under the glass eye. Should be getting this build done here soon. Its going to be a stunt so no sound. So let me know what you think.
Parts:
Dual 22 gauge wire
1/16Heat
1/16" Heatshrink tubing
Cclip
MPS Clip
MPSI4B
Brass MPS Insert style 4
8323TSB
8-32 x .3" black thumb screw
SeoulP4Kit
Build Your Own Seoul P4 Electronics Kit •4AAA Battery Holder with JST connector
•Seoul P4 (White)
•Collimator Lens 5° viewing angle
•3.3ohm 5w resistor
•Push on/push off switch with red button
•Seoul P4 Lens Holder
TWShow
LED Trans White Show blade 1" OD (34 inches) •** White Standard
DF4DEEPFL
4" Deep fluted double female threaded connector
DF4
4" Double female threaded connector
Sledholder12
Screw on LED blade holder style 12
NHS2
MHS "new style" Heat Sink V2
MPS5
MPS Pommel style 5
doublemale
Double ended male threaded connector style 1
GraflexEye
Graflex Glass Eye Replica Thumbscrew
Bmbutton
Black machined button for Covertec clip
8-32Cov
8-32 x 1/4" socket head
Corb1Show
LED "Corbin style" Show blade 1" OD (34 inches) •** Double Wrap
•** Standard
Bookmarks