One leg of the clash sensor needs to be attached where the board says HIT the other goes on VCC. VCC is the positive side of the blade circuit on that saber, and is shared with the clash sensor. The above picture was not from doing a conversion, it was from installing the board in an MHS saber.
Are you saying you broke this connector:
i'm not sure why you disassembled it that far...there's really no reason to do so on a conversion, unless you were attempting to modify the board as shown in the other topic. You can solder the wires directly to the battery interface, but you'll have to make sure they are soldered to the correct pads where the pins were on the connector, otherwise you risk damaging the board when you power it up.
Reply With Quote
Bookmarks