Ok so the electronics for my lightsaber are a simple 4 AA battery holder a seoul p4 green led a 150 ohm 1/4w resistor 1 16mm anti vandal latching green ring switch and i 3.3 0hm 5w resistor

1. I should go from red wire on my battery to the 3.3 ohm 5w resistor
2. Then into the switch from the resistor
3. Then from the switch into the 150 ohm 1/4w resistor
4. From the second resistor into to the positive end of the seoul p4 green led and
5. Then the black ground straight into the negative side of the led.

I hope i have this right. If not please post either a diagram or just step by step instructions. I may or may not have the resistors backwards i cant remember.
Thank You