01234
01234
Last edited by tferroato; 12-14-2017 at 07:31 PM.
I have no experience with these, so take this with a grain of salt. But if it were me I would hack the 3/4 bubble off the end to test out the material. If you don't like the finish on the cut, try a hack saw. You've got 2 practice cuts you can make before you are down to your goal of 4 bubbles.
Don't touch that please, your primitive intellect wouldn't understand alloys and compositions and things with... molecular structures. -Ash /Army of Darkness
I wouldn't use a dremel because you will melt the plastic....I would use a hacksaw and cut 1/2 bubble away then sand the rest so that you don't muck up the bubble strip
Try not. Do or do not, there is no try.... Yoda
CLICK HERE FOR ALL YOUR ECONO SOUND BOARD WIRING DIAGRAM NEEDS!
THREAD INDEX
LDM's Basic Saber-build Step-by-Step Tutorial
Bookmarks