IMG_7417.jpgIMG_7416.jpgIMG_7418.jpg
I pulled apart a broken $10 crap lightsaber. Though its made of plastic, I really liked the design on it. I want to see if any of you can make schematics for the design in MHS.
Hilt Design
IMG_7417.jpgIMG_7416.jpgIMG_7418.jpg
I pulled apart a broken $10 crap lightsaber. Though its made of plastic, I really liked the design on it. I want to see if any of you can make schematics for the design in MHS.
http://forums.thecustomsabershop.com...mhsbuilder.php
Fiddle with this and you should be able to come up with something. You'll need to do an overlay for the ribbed bits.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Since I've never seen an explanation on it, how do you attatch overlays?
Depends on the overlay and the design of the saber. Small overlays can be attached with epoxy. Larger ones are usually held in place with screws, switches, etc.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Playing with MHS Builder...
saberconcept001.jpgsaberconcept001_partsList.jpg
You will need to buy MHS Sleeve material or sink tube to make those three "ring" like overlays.
Last edited by vadeblade; 05-27-2012 at 01:42 PM. Reason: wrong image
-------------------------------------------
"To invent, you need a good imagination and a pile of junk." - Thomas A. Edison
Very nicely done vadeblade. I wanted to see how people would attempt to make it in the MHS builder. This may possibly be my next saber build.
Posting Permissions
Reply With Quote
Bookmarks