okay. will the setup that is about 3 from the top here http://www.thecustomsabershop.com/sa...p?TOPIC_ID=389 eliminate the flashing problem? I used search and didn't find a definite answer, so please help me.
hasbro wiring question
okay. will the setup that is about 3 from the top here http://www.thecustomsabershop.com/sa...p?TOPIC_ID=389 eliminate the flashing problem? I used search and didn't find a definite answer, so please help me.
If you use the one that has two buttons, yes. The corbin one will too. The rest that use the output of the Hasbro to run the LED will not get rid of the flash on clash.
To eliminate the second switch you could go with the use of a relay. Use the output of the Hasbro to trigger the resistor. Just like the EL setup.
<center>Read the FAQ or x-wing won't be happy.
Before posting did you check the Thread Index?.
</center>
could you give me a diagram of the relay setup please?
Oh, nevermind... I was spacing. lol, I was looking at the topic for it and I messed it up there too. You have to have a non-flashing board for that to work.
<center>Read the FAQ or x-wing won't be happy.
Before posting did you check the Thread Index?.
oohhhh! well thanx for such a quick reply, and for clearing up that question.
Posting Permissions
Reply With Quote
Bookmarks