Hi all!
I have a couple of questions ahead of a build I want to do fairly soon, and I'm utterly stuck for the answers. Being located in Britain, makes shipping costs a real pain should I get this wrong, so:
I'm wanting to position my switches discretely in choke style 3 (long). I gather the material gets pretty thick towards the ends, and this is pretty much the source of my troubles.
I want to place 2 momentary switches side-by-side towards the female end of the section. As regards the internal space i think this might be the best option, IF its long enough. http://www.thecustomsabershop.com/SP...itch-P285.aspx
If it will be long enough, does anyone know what size of hole I'll need to ask for when I place the order? I had wondered if the mounting service for switch 22 might do the job (Based on the pictures). The other option I had considered was using switch 20.
(I'd also be open to any other bright ideas here! )
The Black dot on the picture indicates roughly where I had in mind for the two switches. I definitely would prefer them at that end of the saber, though most of the electronics will be going at the other end.
NB: I fully expect to have to cut the heat sink down with this design.
Saber.jpg
EDIT: Drat! Dont know what I hit there, The thread was supposed to have a better title than that!
Bookmarks