This might be an incredibly dumb question, but I've never worked with EL-wire before, and there's a ton of conflicting info out there.
Would it be possible to run EL-wire accents off of the 3.3 volt accent LED pads on the Petite Crouton? Seems to me that if I could put a small inverter in line between the pad and the wire, then the voltage should be just right (as I'm seeing a lot of "EL-wire costume kits" that run off of 2AA or 2AAA).
Anybody tried this, or have some good insight as to why it couldn't be done?
Bookmarks