Hilt insulation

[Evilpancreas]

What do you guys use to insulate your hilts? I might be able to make a chassis using PVC piping, but I'd prefer to use something that wil fill up the hilt.

[TuxedoCartman]

I found some heat-shrink tubing that is nearly the exact diameter of the inside of most MHS parts. Since its just slightly larger, I slit it length-wise, and let it overlap on itself. Line the inside of the saber like this, and voila.

[Evilpancreas]

Sweet. I didn't want my bits and pieces to rattle around in the hilt while I was flailing the saber.

[Kevin Starwaster]

M&M minis tube for certain extension pieces which are 1.15" inside. The tube has a bit of taper and which means a slight reduction in available space towards the end but it has possibilities. I think it was Silver Serpent who clued me in about the Minis tube for making a speaker holder that would fit in my R/B extension but I've played around with other uses, like making cradles or chassis disks out of the lid. Anyway you could use that to line with

[Jin Ke]

I've always just used packing foam... You can cut it down to any shape or size you need.