Hello! New poster here, though I've lurked for a while and read just about every thread I could find. I still have a few scattered questions before I'm ready to finish my design and post my parts list, though, so any advice here would be appreciated.
In no particular order -
>What is the diameter of the top of a recessed AV momentary switch? The gold plated, item code (switch18) if it makes a difference. I can't find it listed, and am trying to place it within 1/16th or 1/32nd of an inch to assist in cram fu.
>Am I correct that attaching a covertec belt clip does not take up any internal space? I won't have much space to spare, and haven't yet decided whether to include a belt clip at all, so this'll factor greatly into that decision.
>I've seen a lot of information on how to implement heat sinks, some of it contradictory. For using the new style MHS blade holder and heat sink, specifically, what else would I need for it? Thermal tape, metal screws for thermal conductivity, plastic screws for the Seoul LED, some combination thereof?
>What sort of damage mitigation would be recommended to have on hand while making a Li-Ion battery pack (of two 14500 3.7V batteries)? Eye protection I'm sure, what about gloves? A bucket of sand? I've not worked with electrical hardware before, what might be needed?
>How much does a Petit Crouton soundboard's placement close to the hilt's spin center affect sound quality, given 0.5" - 0.75" of resonance? It'll be almost exactly at the center unless I severely rework my design.
>Does sealant or a clear coat of paint damage or mess up powdercoating in any way? I understand this isn't necessary for the powdercoat, but planned to paint some detail work in a second color after receiving the pieces.
- - - - -
If I've noobed up and missed something I could've searched for, I apologize. Thanks for any help you can provide!
Bookmarks