I brought my Lathe DC motor control board into work to try and figure out what was wrong with it. THey found the faulty component, and pulled the part off the board, but i am having problems finding a replacement....I figured what the hell.....someone on here may recognise the writing on it and be able to point me to a site that may cary it. THe shop said that it was a "micro controler" or something liek that....its physical dimentions are roughly(lol...roughly....lol....just remembered i have a electronic digital caliper...duh....)okay...exactly....lol....
.25"/6.29mm long
.1695"/4.31mm wide
.1515"/3.83mm tall
the type on the top reads: v531t the second line holds a lowercase looking block "f" symbol followed by 817c
so it reads:
v531t
F 817c
It has four pins BTW.....
Thanx if anyone can help me tracking it down, though i doubt anyone will know....
Ambo
<center></center>
<center>Look at my photo album.</center>
Bookmarks