First MHS Saber Question

[Coondawg45]

Hello community. This is my first MHS saber build. I have been doing sink tube builds for years but I really like some of the parts that are offered now with MHS. My big question about this build is do I have enough room on the inside for my electronics. I didn't see a measurement of the inner diameter on the parts page. I've been searching for a couple of hours through past post and I can't find the measurements. Can a soundcard + battery pack fit into this hilt? My plans are to place the speaker on the bottom of the battery pack. The soundcard will be located in the middle of the hilt and the switch will go in the middle of the 2 inch extension just under the blade holder. My concern is space. I am open to any suggestions on how to make this saber better. Thank you for your time.

[Coondawg45]

Someone answered my question about the measurement. I am still curious as to what options I have as far as placing a soundcard and batter pack in this hilt. Thanks

[Ronan]

Thats a lot of room, no problem.

I could fit electronics for 2 sabers with sound in this one, maybe even more.

[Coondawg45]

Thanks Ronan. I appreciate the help.

[xl97]

since the ribbed section have a smaller ID than regular MHS parts..

Id say it depends on the battery solution you are trying to use (custom pack/stick?).. and the soundboard you are using.