First Attempt
Seoul P4 electronics kit
- 4aa battery holder
- Seoul p4 blue
- 3.3 ohm 5w resistor
- seoul p4 lens holder
- collimator lens 5" viewing angle
Blade holder style 17
Mps pommel style 17
Mps clip
Mps insert 12
7" double female threaded connector
150 ohm 1/4w resistor
8-32 x 1/2" Thumb screw
Mhs choke style 1
Tall bezel
Mhs new style heat sink
Dpdt blue illuminated latching switch
Please let me know what you think!
Originally Posted by Kayan Sunburst
I don't see a style 17.
you should post pic from the builder
Wise words do not distinguish a Consular, but the choices they make.
-----------------------------------------------------------------------------------
A Jedi uses the Force for knowledge and defense, NEVER for attack.
Haha silly me thats what I get for doing this from my phone
it should be pommel style 6
I've also changed it up a bit and went with a fluted style main body with gaurded hole. Will this work with my latching switch?
Here is a picture, I've been playing with powder coating as well.
SaberBuilder_render.jpg
Last edited by Kayan Sunburst; 12-04-2011 at 12:08 PM.
No, An AV switch is not a guarded switch (well, it is, but not the size that hole was intended for.) You will have to have the hole widened and probably add a Bezel (which you have)for it to fit If possible switch it to a SPST switch instead they are smaller. The DPDT ones are huge and you probably aren't planning on using the other side of the switch so don't really need a DPDT.
You will have to have the hole enlarged. There is a place for this in the store.
If i wanted the same style switch I would have to switch to momentary? You have to hold momentary down? If I.understand what Ive read.
Yes, unless you have a driver that can make the momentary work like a latching, you will have to hold it down, which probably isn't acceptable, at least it wouldn't be for me.
You should be ok, as long as you have the tall bezel.
In my hilt I have one of the activation boxes with a DPDT switch and it only leaves maybe an 1/8th of an inch clearance between the leads on the switch and the wall of the hilt when all together. So as long as you don't need anything to go under that switch you should be ok.
Awesome! Thanks Zzan
Posting Permissions
Reply With Quote
Bookmarks