01234
01234
Last edited by tferroato; 12-14-2017 at 07:36 PM.
You can take a dremel to the trim rings and remove the inner locking ring so that they slide over MHS parts. You'll have to find a new way to attach them though. A 2-part epoxy should do the trick. They don't come in brass, though there is an anodized yellow that looks pretty good.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Yeah you're right. I just measured mine. You'd need to open them up a bit more. They're 1.45" ID, not counting the locking ring.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
I buy solid brass rings and use a dremel to grind out the inside.
Posting Permissions
Reply With Quote
Bookmarks