So I read the posts for noobs, I checked the index and I searched several times before posting this, so I apologize up front if I missed the answer to this question, but I'd like to confirm this prior to completing the first of two maul conversions.
I'm getting ready to reassemble the pieces and I'm not clear on where the blade retention screw should be placed. According to Tim's directions I need to mark the exterior of the hilt and drill through the body and balde holder. What do I do with the old MR pin that ran through the hilt body below the emitter? Is it possible to reuse this hole and drill into the blade holder for the set screw? Or is that pin placement to low and would it go through the heat sink? I'd rather not make another hole in the body unless necessary. Does anyone have a recommendation of where to put the retention screw so that it's somewhat hidden? Also, am I correct that the only item holding the blade, blade holder is the retention screw? The board and battery pack are just sandwiched in between the blade holder and end cap, correct (besides the actual wired connection between the board and LED)?
Thanks in advance for your assistance!
Danny
Bookmarks