I wasn't exactly sure if it was the right move but I soldered the grey wire (from the multi colored harness) to the opposite side that the blue wire(the one that pairs with the purple wire and goes to the positive wire from the LED) was attached to on the clash sensor board. Everything besides the clash sensor is working so Im assuming I did it wrong. Can anyone give me detailed instructions on how that clash sensor is supposed to be wired? pictures or a sketch would be great. I am a noob when it comes to electronics, but great at following directions. Please remember this is for the 05 MR vader with the quick disconnect plug (the one MR designed for a removable blade but never implemented). Thanks for any help!
Bookmarks