PC-L goes in idle-mode but does not light up when pressing the switch

[andrue1988]

Hallo Saber smiths

i have a problem and need your help, because i cannot find a solution.

it is my first saber. using a PC-L with one accent LED and an indicator LED. 2 Li-ion power cells with 3,7 V and 2600 mAh each are used with protection circuit for 2 cells.
when I pull off the kill plug, the sabe goes in idle mode, indicator LED lights up bright, and the accent LED starts blinking. but when push the AV button of the saber, it doesn't light up. The high Power LED ( green seoul p4 ) stays off.

cannot find any solution for my problem. can someone here help me please? thank ya all.

[Sunrider]

You wired the LED backwards?

[Darth Xusia]

That would be my guess too. Maybe some pics of your wiring would help.

[andrue1988]

no, according to my wiring sketch, everything is wired correctly and the high power LED does light up for very very short, when i pull out the charging plug. i can just describe further things, my saber does or things i noticed:

as i said: indicator LED lights uo and accent LED on the switch is blinking. speaker gives the typical sound when going in idle mode.

- the paramters for the shimmering and flickering on the light meat SD card were named a lil bit else than in the PC-L manual
Schaltplan-PCB.jpg

[thrgk]

Didnt you wire the Aux switch and AV switch wrong? should be reverse i thought. Im a noob tho lol.

[andrue1988]

no, the wiring of the AV and aux switch is copied from the sketch in the PC-L manual. I consulted a lot of people with my wiring sketch and all of them confirmed the sketch would be right. the more i think now, there is a lose soldering point on the board. i will see tomorrow. good night smiths ( after midnight here in germany )

[Sunrider]

With close up pics we may be able to spot something.