http://forums.thecustomsabershop.com...05vader/16.jpg
This picture says to punch out the pin... but mine does not have a exit hole... seriously their is no hole on the other side to push it through. anybody else have this issue?
problems with 05 conversion
http://forums.thecustomsabershop.com...05vader/16.jpg
This picture says to punch out the pin... but mine does not have a exit hole... seriously their is no hole on the other side to push it through. anybody else have this issue?
Just push the pin in til you can slide off the blade.
Hokey religions and ancient weapons are no match for a good blaster at your side, kid.
ahhh..i tried that and i guess i didnt do it hard enough
Edit: Look i tried hitting it with everything i've got. It doesnt seem to wanna push in any bit at all! What am i doing wrong?
Last edited by Natesroom; 08-15-2011 at 08:03 PM.
The end of the pin is knurled so it wont move on it's own. I put the blade and everything in a V-lock to hold it still, and used a nail set and tap hammer. Then slowly drove it in til the pin is in enough to slide the blade off. Its not as long as the others.
Last edited by Ari-Jaq Xulden; 08-15-2011 at 09:01 PM.
Hokey religions and ancient weapons are no match for a good blaster at your side, kid.
Yeah i got the others off and they were knurled (jerks) but this ones a pain the arse!
Posting Permissions
Reply With Quote
Bookmarks