Ok, I just finished swapping out all the wires and adding the clash sensor (which was mounted on the blade of the toy) to the 2011 Ultimate FX board . I'm now to the point of swapping out the swing sensor. Looking at the pictures I've added, you'll see there are what seem to be 2 swing sensor mounting locations, one for the Vader saber and one for the Anakin saber. This card was from the Anakin so the Vader is empty. I was going to try intalling 2 swing sensors perpendicular to each other on a strip board and wire that to the soundboard (as suggested by Skottsaber for the 2010 Obi-wan econo board), but it seems you might be able to just mount one to the Vader side and one to the Anakin side. I'm admittedly a noob when it comes to sabers and circuitry, but it seems like it's at least a possibility. Anyone more experienced care to chime in?
Also, I noticed that there are 3 holes, but only 2 wires one the swing sensor from TCSS. How would one even wire in the TCSS swing sensor? I've labeled them 1, 2 & 3 so someone can easily just tell us which ones would go where.
Attachment 6246Attachment 6247
Bookmarks