LED blade holder style 20

[Yoshi-Taka]

"This has 2x 10-32 holes, 1x 8-32 hole, and the 4 small holes threaded for the graflex electrical pins."

Sometimes reading the Store description helps.

I did read it, but I had to be sure. It never hurt to ask.
Thanks

[cooky069]

i was really excited to finally see a graflex style blade holder only problem no graflex style nobs listed in store anymore (bangs head against wall )

[Jedi Mynock]

um, i can basically throw my shroud in the trash now.
that thing is... AWESOME!
sure, it would be great to get the ears on there somehow, but just bolt on some fabbed sheetmetal!

i am going to order that bad boy for SURE. gonna go great with my 4 inch deep flutted extension!!!

new parts in the shop is better than seeing the next wave of figures! lol

[Darth Odious]

Pure awesomeness. Looking to pick one up next payday with the deep grooved 4 in extension.

Now if Tim makes a Heliand/MPP blade holder I will squeal. It will be a manly squeal, but a squeal nonetheless.

[jin starkiller]

picked this up and arrived yesterday ..pics don't due it justice very awsome peice

[Tahm]

This is the saber I built with Tim's prototype last Halloween, It seems the same as the current BH20 but I had him drill an additional hole (for bunny ears [not shown]) and it uses the older style heat sink.

DSC00795.jpgDSC00796.jpg

[Hasid Lafre]

Looks good.

[Xanatos1986]

I will be making a MHS luke a mix between the anh and esb one. I have bunnie ears and the hoop already made I just need to get the holder and test fit it all