"Apprentice" MHS rebuild

[KuroChou]

After having completely failed to finish my original scrap steel hilt "Apprentice," I decided my first MHS build would be a resurrection of the same design.


Original Steel Hilt


MHS Render


Possible Weathering

Shopping List (subject to final chassis design)
TCSS:
Pommel 2
3" extension
7" extension
double-male adapter (or gender changer)
trim ring 1
BH 1
silver protected switch (M/L depending on soundboard)
18" sleeve
4xChassis disk 3
3x4-40 threaded rod
3x3/16" alum. tube
12x4-40 nuts
Premium speaker
8-32 thumb screw (+ BH drill&tap service)
7.2v Li-Ion PCB
2xtrustfire 14500
recharge port

Other Sources:
3x4-40 torx head machine screw
1.5" heatshrink

Depending on internal space constraints, the recharge port will either be in-pommel, or inside a custom covertec knob made out of 5/8" roundstock that would thread into the hilt.

[brett]

Really like the unfinished steel saber, very nice design, and admirable to be able to construct something like that from scrap parts,and the CSS one is looking great at concept stage. I always am amazed at how almost any design can be built using CSS parts (within reason of course) and your creation is a perfect case in point.Good luck!